3.5 上升时间/Rise time: 当输入115Vac和输出比较大负载时比较大时间为40 mS. 40 mS M 3.6 保持时间/Hold up time: 当输入115Vac 和输出比较大负载时,相当小保持时间为5 mS . 5 mS M 3.7 效率/Efficiency: 当115/230Vac输入电压时，1/4，1/2，3/4和满载计算平均效率，相当小77.65%。 77.65%Min, At 115/230Vac input voltage,1/4，1/2，3/4 and full load calculation average efficiency. 适配器满足能效V。 Adapter meet efficiency lever V。 3. 轴向振动/Axes,10 cycles per axis. 在测试过程中不能出现长久性的损坏. No permanent damage may occur during testing. 在电源开启和关闭后,样机能够恢复到相当初条件. The SAMPLE has to restore to its original situation after power off/on.. 5.5 跌落试验/Dropping Packed: 插墙式跌落高度为1米、桌面式跌落高度为760mm； 1M for wallmount type and 760mm for desktop type as above described; 测试台面是厚13mm的夹木板，离地面高19-20mm The horizontal surface consists of hardwood at least 13mm thick, mounted on two layers of plywood e广东13V1A日规PSE认证电源适配器

6、安全及EMI要求/SAFETYAND EMI REQUIREMENT: 6.1 安全:符合标准 Safety:accord with 6.2 高压/DIELECTRIC STRENGTH Hi-Pot: 初级对次级/Primary to secondary: 3000Vac/10mA/60S or 4242Vdc/5mA/60S for type test. 6.3 绝缘抗阻/Iusulation resistance: 初级对次级/Primary to secondary:20MΩ min at 500V DC. 6.4 EMI标准/EMI STANDARD Meets the Limits of/测试符合 <1>.Fcc part15 class B rules <2>.EN55022 class B rules <3>.GB9254-1998,GB17625.1-2003 <4>.AS/NZS CISPR22:2006. 安规认证符合：CE、GS、CB、UL、FCC、CSA、BS、SAA、CCC、PSE、KC东莞5V2A日规PSE认证电源适配器

1、描述/ DESCRIPTION: 本规格书适应于CKA-Q30W The purpose of the document is to specify the functional requirements of a 30 Wswitching power supply. 2、输入特性/INPUT CHARACTERISTICS: 2.1输入电压/Input Voltage: 额定电压/Rated Voltage:100~240Vac 调整范围/Variation Range:90-264Vac 2.2输入频率/Input Frequency: 额定频率/ Rated Frequency: 50/60Hz. 调整频率/Variation Frequency:47-63Hz 2.3输入电流/Input Current: 当输入交流电压为额定值的下限电压负载满载时,比较大输入交流电流0.8A. 0.8Amps maxAt any input voltage and rated, DC output rated load. 2.4浪涌电流/Inrush Current: 当输出为额定负载,环境温度为25℃,输入240Vac冷态起机时无损坏. When the output of the rated load, the ambient temperature is 25℃, input from 240Vac cold machine without damage to 2.5 AC漏电流/Ac Leakage Current: 当输入电压240Vac时,比较大漏电流为0.25mA. 0.25mAMax.At240Vacinput.

3、输出特性/OUTPUT CHARACTERISTICS: 3.1 输出功率/Power output 电压 Voltage 相当小负载 Min. Load 额定负载 Rated. Load 峰值功率 Peak 输出功率 Output power 5.5-24 0.01A-4A 0W 2 负载特性,调整率/Combined Load/Line Regulation 电压 Voltage 相当小负载 Min. Load 额定负载 Rated. Load 线性调整 Line Regulation 负载调整率 Load Regulation 5.5-24Vdc 0.01A-4A ±2% ±5% 3.3 纹波和噪音Ripple and Noise: 测试条件:在输入115/230Vac 和输出相当小及比较大负载时,使用示波器带宽为20MHz 连接到适配器的输出端,同 时输出端并联一个47uF的电解电容和一个0.1uF的瓷片电容. At 115/230Vac input and output Min and Max.Load, the ripple and noise are as follows when measure with Max.Bandwidth of 20MHz and Parallel 47uF/0.1uF,crossed connected at testing point. 电压比较大纹波/比较大噪音 Voltage Ripple and Noise(Max.) +5.9Vdc 120mV p-p 3.4 启动延迟时间/Turn on delay time: 当输入115Vac和输出比较大负载时,比较大启动时间为2S. 2Seconds M

3. 轴向振动/Axes,10 cycles per axis. 在测试过程中不能出现长久性的损坏. No permanent damage may occur during testing. 在电源开启和关闭后,样机能够恢复到相当初条件. The SAMPLE has to restore to its original situation after power off/on.. 5.5 跌落试验/Dropping Packed: 插墙式跌落高度为1米、桌面式跌落高度为760mm； 1M for wallmount type and 760mm for desktop type as above described; 测试台面是厚13mm的夹木板，离地面高19-20mm The horizontal surface consists of hardwood at least 13mm thick, mounted on two layers of plywood each 19mm to 20mm thick,all supported on a concrete or equivalent non-resilient floor. 6、安全及EMI要求/SAFETYAND EMI REQUIREMENT: 6.1 安全:符合标准 Safety:accord with 6.2 高压/DIELECTRIC STRENGTH Hi-Pot: 初级对次级/Primary to secondary: 3000Vac/10mA/60S or 4242Vdc/5mA/60S for type test. 6.3 绝缘抗阻/Iusulation resistance: 初级对次级/Primary to secondary:20MΩ min at 500V DC. 6.4 EMI标准/EMI STANDARD Meets the Limits of/测试符合 <1>.Fcc part15 class B rules <2>.EN55022 class B r常州10V1.5A日规PSE认证电源适配器

广东13V1A日规PSE认证电源适配器

3、输出特性/OUTPUT CHARACTERISTICS: 3.1 输出功率/Power output 电压 Voltage 相当小负载 Min. Load 额定负载 Rated. Load 峰值功率 Peak 输出功率 Output power 5.5-24 0.01A-4A 0W 2 负载特性,调整率/Combined Load/Line Regulation 电压 Voltage 相当小负载 Min. Load 额定负载 Rated. Load 线性调整 Line Regulation 负载调整率 Load Regulation 5.5-24Vdc 0.01A-4A ±2% ±5% 3.3 纹波和噪音Ripple and Noise: 测试条件:在输入115/230Vac 和输出相当小及比较大负载时,使用示波器带宽为20MHz 连接到适配器的输出端,同 时输出端并联一个47uF的电解电容和一个0.1uF的瓷片电容. At 115/230Vac input and output Min and Max.Load, the ripple and noise are as follows when measure with Max.Bandwidth of 20MHz and Parallel 47uF/0.1uF,crossed connected at testing point. 电压比较大纹波/比较大噪音 Voltage Ripple and Noise(Max.) +5.9Vdc 120mV p-p 3.4 启动延迟时间/Turn on delay time: 当输入115Vac和输出比较大负载时,比较大启动时间为2S. 2Seconds M广东13V1A日规PSE认证电源适配器

深圳市成康安科技有限公司是一家有着雄厚实力背景、信誉可靠、励精图治、展望未来、有梦想有目标，有组织有体系的公司，坚持于带领员工在未来的道路上大放光明，携手共画蓝图，在广东省深圳市等地区的家用电器行业中积累了大批忠诚的客户粉丝源，也收获了良好的用户口碑，为公司的发展奠定的良好的行业基础，也希望未来公司能成为行业的翘楚，努力为行业领域的发展奉献出自己的一份力量，我们相信精益求精的工作态度和不断的完善创新理念以及自强不息，斗志昂扬的的企业精神将引领深圳市成康安科技和您一起携手步入辉煌，共创佳绩，一直以来，公司贯彻执行科学管理、创新发展、诚实守信的方针，员工精诚努力，协同奋取，以品质、服务来赢得市场，我们一直在路上！